Ptac Wall Sleeve Installation

Place the unit into the sleeve and screw it in place.

Ptac wall sleeve installation.

If the sleeve projects more than 8 into the room a sub base or other means of support must be used. Wall sleeve is secure and properly sealed to the wall. The wall sleeve be installed a minimum of 36 from the ceiling. Install a lintel over the ptac unit to ensure the weight of the wall or window isn t putting undue stress on the unit.

The sleeve will fit flush in the wall extending outside the structure. When installing a ptac unit an anchored stable installation will improve performance and increase longevity. Power it on and test it. All wall and window wall installations must provide for proper drainage.

It s a good idea to frame the ptac unit with substantial secure wood studs. Keys to proper installation. Caulk along the outside sleeve edges to prevent leaks. Apply sealant to completely fill this pocket.

Supporting and sealing sleeve to their frames. Wall sleeve installation 920 087 04 8 05 wall sleeve installation instructions pdxws note. Insure that the unit is only installed in a wall structurally adequate to support the unit including the sleeve chassis and accessories. While the dimensions may appear to be incompatible the 2 devices should fit properly.

There is a portion of the air conditioner which extends a few inches back into the room. In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended. To ensure proper airflow and filter removal it is recom mended installation of the wall sleeve be a minimum of 36 from the ceiling. Cooper and hunter 9 000 btu ptac packaged terminal air conditioner with heat pump pthp unit full set including steel installation sleeve and grille 5 0 out of 5 stars 1 1 055 00 1 055.

Unit has a slight rearward slope within wall sleeve for proper drainage use tapered foam blocks. Install the sleeve and secure with mounting fasteners. Air conditioner unit is centered in wall sleeve and sealed with foam pads to prevent air leakage. Every scenario will be different with wall type and power always changing.

Sleeve must be tight against the bottom shim and fully bedded into sealant. Inches mm inches mm inches mm wall sleeve only 3 75 0 0 0 0 subbase kit 3 75 3 1 4 85 2 3 4 70. It is the insta oohu vuhvsrqvlelolw to ensure there is adequate drainage for the ptac. The air conditioner will slide into the sleeve but is not flush with the wall.