Patching Door Lock Hole For Reuse

Repairing a hole in exterior wood doors.

Patching door lock hole for reuse.

Tap the dowel plug into the hole as far as possible aligning the grain pattern of the dowel rod vertically. If the latch does not reach the strike plate shim out the plate or add another strike plate on top of it remove the screws and run them through both plates. Allow the glue to dry overnight. Step 2 stuff some paper towels down inside the hole.

For wood doors that are solid or when the unwanted hole is in an area of the door that is solid the most effective technique to repair the unwanted hole is to cut a piece of dowel that is the same diameter of the unwanted hole slightly longer about 1 32 inch than the thickness of the door. Inject a liberal amount of foam to be sure the entire area under the damage is filled. Insert the tube into the damaged area so that the foam sticks to the back of the other side of the door and fills the void completely between the door panels. This will provide a ledge of sorts for the foam insulation to sit until it is dry.

A dowel of the proper diameter works well for the rounded hole in the door edge left by the. Replace the plate fill the gap at the top or bottom with wood putty and refinish. Remove the old lock if it is still installed. If the latch still will not reach shim out the door s hinges.

For durability and structural integrity it s hard to beat real wood when filling a large hole in a door. Remove the four corner screws from the plate on either side of the door and pry the plates away gently with a flat screwdriver blade. Step 1 remove any loose pieces from around the hole. Hold the knife at a slight angle to create a beveled cut and use a gentle sawing.

Use your utility knife if needed. How to repair hollow core door holes. Use insulating foam sealant to fill the hollow area behind the defect in the door panel.